The stainless steel air purge collar is used to keep dust, moisture, airborne particles, and vapors away from the lens. It can be mounted before or after the bracket. A 4mm (.16 in) outside diameter plastic tubing is recommended to connect the fitting. The pressure of air should be between 0.6 and 1 bar (8.7 to 15 PSI). Clean, oil free air is recommended.

The air purge collar is used to keep dust, moisture, airborne particles, and vapors away from the lens. It can be mounted before or after the bracket. A 4mm (.16 in) outside diameter plastic tubing is recommended to connect the fitting. The pressure of air should be between 0.6 and 1 bar (8.7 to 15 PSI). Clean, oil free air is recommended. (Metric Thread)

The right angle mirror is used to turn the field of view by 90 degrees against the sensor axis. It is recommended when space limitations or excessive radiation do not allow for direct alignment of the sensor to the target. The mirror must be installed after the bracket and the air purge collar and must be screwed in fully.

Thermocouple Cable Extension Connector Kit for Raytek CM or CI1 sensors that use Type J Thermocouple.

Thermocouple Cable Extension Connector Kit for Raytek CM and CI2 sensors that use Type K Thermocouple.

The Raytek communications box is used with MI3 Series sensors to power and display sensor readings.

• Outputs: 0-20 mA, 4-20 mA, 0-5 V, 0-10 V, Type J, Type K, Type R, Type S
• Digital Interface: USB 2.0
• Housing: NEMA 4 (IP65) Die-Cast Zinc

The Raytek communications box is used with MI3 Series sensors to power and display sensor readings.

• Outputs: 0-20 mA, 4-20 mA, 0-5 V, 0-10 V, Type J, Type K, Type R, Type S
• Digital Interface: USB 2.0 (RS485 optional)
• Housing: NEMA 4 (IP65) Die-Cast Zinc

The Raytek communications box is used with MI3 Series sensors to power and display sensor readings.

• Outputs: 0-20 mA, 4-20 mA, 0-5 V, 0-10 V, Type J, Type K, Type R, Type S
• Digital Interface: USB 2.0
• Housing: NEMA 4 (IP65) Die-Cast Zinc

The Raytek communications box is used with MI3 Series sensors to power and display sensor readings.

• Outputs: 0-20 mA, 4-20 mA, 0-5 V, 0-10 V, Type J, Type K, Type R, Type S
• Digital Interface: USB 2.0
• Housing: NEMA 4 (IP65) Die-Cast Zinc

The Raytek communications box is used with MI3 Series sensors to power and display sensor readings.

• Outputs: 0-20 mA, 4-20 mA, 0-5 V, 0-10 V, Type J, Type K, Type R, Type S
• Digital Interface: USB 2.0 and Profinet IO
• Housing: NEMA 4 (IP65) Die-Cast Zinc

The Raytek communications box is used with MI3 Series sensors to power and display sensor readings.

• Outputs: 0-20 mA, 4-20 mA, 0-5 V, 0-10 V
• Digital Interface: USB 2.0
• Channel: 4-Channel
• Housing: Molded Plastic

The Raytek communications box is used with MI3 Series sensors to power and display sensor readings.

• Outputs: 0-20 mA, 4-20 mA, 0-5 V, 0-10 V
• Digital Interface: USB 2.0 and RS485
• Channel: 4-Channel
• Housing: Molded Plastic